Four-Axis Measurement: Faster, More Accurate, More Reliable
F4010-K are based on the principle of laser diffraction (Fresnel diffraction), with a simple structure that can provide stable and
accurate measurements for a long service time.
The four-axis measurement solution minimizes blind spots, perfectly meeting the stringent requirements of industries such as cables, wires, and pipes for the continuous production of high-quality products.
F4010-k is versatile, applicable to various materials such as electric wire & cable,steel wire, enamelled copper wire, medical tubing, 3D filament, and more, regardless of their transparency.
4-axis measurement ,Less bind area
The below figure explains the relation between the measurement result and nos of axis. The
more nos of axis, the less bind area it is , and measurement accurate will be more accurate.
lump and necks detection
Compare each single measurement value with running average value, If a single measurement is more than running average value and higher or lower than threshold value, then it is a defect.
Touch Screen,Computer,Cellphone
DALA F4010-K can be managed by computer ,cellphone and Touch screen,like parameter setting ,measurement data management ,
and so on,customers can choose as their application request.
Technical Specification
| Model | F4010-K |
| Axis | 4-axis |
| Measurement data | diameter and ovality, lump and necks |
| Frequency | 40KHz |
| Measurement range | 0.3~10mm |
| Repeatability(1) | ±0.2μm |
| Accuracy(2) | diameter accuracy:±(0.001+0.01%*D)mm ovality accuracy: ＜0.5mm:±0.004mm ≥0.5mm: ±2(0.001+0.01%*D)mm |
| Min defect height | 0.01mm |
| Min defect length(3) | 0.2mm(wire speed120m/min)
0.8mm(wire speed500m/min) |
| Size | 275*242*60mm |
| Working power source | 24V ±10% 40VA |
| Running temperature | 5℃~50℃ |
| Display | LED display |
| Commuincation port | Standard:WIFI,RS485 MODBUS RTU,CAN
Option:PROFIBUS,PROFINET, EtherNet/IP,EtherCAT |
| Electrical port | Standard: digital output(relay),digital input,analog input,encoder pulse input port
Option:PI feedback control (4) |
| Data colletion & analysis | available (option DS14 ZT display and control system,DMS1000) |
| Out-of-tolerance alarm | available |
| Transparent mode | available |
Note:
(1) set sliding window as 100ms, outside diameter repeatability of φ1mm round rod at measurement center area
(2) set sliding window as 100ms, outside diameter deviation of φ1mm round rod at measurement area
(3) set defect measurement average time as 0ms, the minimum defect length which cannot be missed at the measurable area
(4) PI feedback control is option, but must order at placing order
